membooster and psu question

[Psy]

i was looking into getting the OCZ Gold Series Dual Channel Kit 184-Pin 1GB(512MBx2) DDR PC-3200 Gold VX, Model OCZ4001024ELDCGEVX-K - Retail , but my motherboard only goes to 2.85 volts (msi k8n neo2 plat) and it needs 3.2v for the tighter timings, so i was looking at the membooster which supports up to 3.4 volts and was tested on this board, now my question, i need a better psu and was chkin out the OCZ ModStream 450W Power Supply with OCZ EZMod technology, SATA Connector, Model "OCZ45012U" -RETAIL, but its a 24 pin, and the membooster specs say it needs a 20 pin, with the adapter for a 20 pin, will this work?
im looking to hit 250 FSB with this.

[BGP Spook]

Hi! Psy. Welcome to BE :welcome:

Your motherboard uses the 20-pin connector right? I know that most of the powerstream models are both 20 and 24. Not sure about the Modstream though.


------------------------EDIT-----------------------------

Yes, the Modstream has a 20 and 24.

Link:
http://www.ocztechnology.com/produc...amSpecSheet.pdf


Circular picture at the bottom of the second page. You can see the 4 pin that slides off the 20.

[Psy]

thanks for the welcome, yes the mb is 20 pin and the psu supports 24 pin, but has an adapter for 20.

[jsimmons]

The modstream's motherboard connector is a two-part affair. The four-pin connector slides off the 20-pin, and voila, everything is fine.