Another Setup help for P4C800-E dlx

[comecum]

Greetings to every ASUS fans!!! My first post....I`ve been reading this forum for a couple of weeks now and help me decide to get Asus mobo.

Just got this board lately and installed all necessary hardware. Installed P4 2.6C 800FSB, 2 x 512 Kingston HyperX PC3500 and 2 new SATA 120GB WD HDD. First how do I set up for Raid 1? On board Promise Controller is ENABLED. On post I press "F6" then press "S" for to Specify additional disk controllers. After this a message appeared.
"Could not find a floppy drive on your machine to load OEM Drivers from floppy disk."
* Press ESC to cancel loading from OEM Drivers
* Press F3 to quit setup.

I have no floppy installed on the system. And already disabled on the Bios setup.

Thanks in advance.
Rommel

[comecum]

Got it, just bought a floppy drive. Everything works flawlessly on stock settings.

[LastRide]

The P4C80-E is a nice board but rather expensive.I just bought one myself.The Kingston HyperX 3500 is bad ram.I would run memtest86 to make sure it doesn't error at its rated speed and vdimm.

[Hawk]

Just a quick observation, you would be better off running the RAID on the ICH5-R connectors over the Promise. . . . ;)

[rasmuslp]

As LastRide says> Run some memtest86 tests and se if it can pass. Mine HyperX3500 couldn't run 200Mhz 2-3-3-7 as they are rated.