PDA

View Full Version : Picked up a 1700+ JIUHB for £42, but it was a D-U-T3C, DOH!


DivideBYZero
07-14-2003, 02:54 AM
So I'm at a computer fair, see a tray of Tbred's, ask to scan em all for codes, see a JIUHB and like the consumer whore I am, buy the JIUHB in a heartbeat.

But it's a DUT3C. I'll let you know how it goes...

Teh real reason I got this is I have an 0308 DLT3C XPMW, but I have done the 5th L3 on this bugger. I still need to hardwire another L3, as I'm bunging this in a KG7 (for the challenge and I am getting married, so can't justify the cash for an NF2 v2). So this is my backup chip!

Wish me luck!
Chuck232
07-14-2003, 04:16 AM
How'd you get a DUT3C if they scanned the codes and found a JIUHB?


Anyways, I look forward to seeing the overclock on that thing..

BTW, what cooling are you using?:wave:
DivideBYZero
07-16-2003, 03:15 AM
Originally posted by Chuck232
How'd you get a DUT3C if they scanned the codes and found a JIUHB?


Anyways, I look forward to seeing the overclock on that thing..

BTW, what cooling are you using?:wave:


No, I scanned the chip there and then, but failed misserably to check the voltage:beat:

I cool with air. The current setup is as follows:

AXIA Tbird@ 1.5Ghz in a GlobalWin 802. Now this 'bird is toasty, but I have her under control with a GlobalWin CAKII38 (Am I a globalwin whore or what?!:D ).

I have two TT Smart fan 2's, one on intake and one on exhaust, set to manual control. Last night I put in a blow hole on the top as I have been noticing a hot spot behind my Enermax. This has a lowly Antec 30cfm fan to just clear the build up.

Last night it was 28-30c in my home office at 10pm. The case temp was 35c and the 'bird idled at 45c. A spot of folding caused it to rocket up to 50c, but hold there. Not really fair as these ambeint air temps are out of the ordinary, but it was a good time to make the hole!
Chuck232
07-16-2003, 04:09 AM
Hehe.. don't worry 50C isn't real high at all for under load and at that speed.

Post something when you get the new chip eh! :D
DivideBYZero
07-16-2003, 05:13 PM
Originally posted by Chuck232
Hehe.. don't worry 50C isn't real high at all for under load and at that speed.

Post something when you get the new chip eh! :D

I put the DUT3C in and it went to 1.8 no issue, but my multiplier is holding me back.

See my new thread on my DLT3C that I have hard wired to 15.