perllog
10-21-2003, 12:46 PM
Hello everybody
So I've just built the new system with DFI Lanparty N2 mobo and Barton 2500+ oc to 3200+, turns out it's not that fast, with a FX 5900 oc to ultra level, I only got 11.5K with driver 45.25 ....But that's not all the bad news, prior to this board I had the MSI M8N2 (?) but switched to this DFI after trying to figure out unsuccesfully how to make use of my D-Link PCI cardbus for the wireless insert (also D-Link) . However this board ie DFI gives me the same result as the MSI mobo, in hardware-device manager popup , both mobos always says resource not enough need to disable something else for it to work , with an error (12) ...I've tried to removed several other unused onboard devices like audio, raid controller but the "not enough resource" error persists. I know I'm missing something basic here , anyone cares to enlighten me on this ? thanks a lot.
Perllog
So I've just built the new system with DFI Lanparty N2 mobo and Barton 2500+ oc to 3200+, turns out it's not that fast, with a FX 5900 oc to ultra level, I only got 11.5K with driver 45.25 ....But that's not all the bad news, prior to this board I had the MSI M8N2 (?) but switched to this DFI after trying to figure out unsuccesfully how to make use of my D-Link PCI cardbus for the wireless insert (also D-Link) . However this board ie DFI gives me the same result as the MSI mobo, in hardware-device manager popup , both mobos always says resource not enough need to disable something else for it to work , with an error (12) ...I've tried to removed several other unused onboard devices like audio, raid controller but the "not enough resource" error persists. I know I'm missing something basic here , anyone cares to enlighten me on this ? thanks a lot.
Perllog